Harness studio
Lay out the loom the way it will sit on the formboard: connectors and terminals, the runs between them, every wire pin to pin. The checks run as you draw. This one starts from a sample engine loom — change anything.
Scratch design — sign in to keep it in a project (each save is a version).Sign in to save
Opening the harness studio…
As a harness job10 ends · 22 wires · 3 notes
- ECU: AMPSEAL (AMPSEAL 16 · 35-way ECU plug) isn't stocked → quoted as DEUTSCH DT; the drawing keeps the real part.
- ECU: DEUTSCH DT comes in 2/3/4/6/8/12 ways, not 35.
- Wire labels and network names stay on the drawing; the job carries heat-shrink labels as a yes/no.